Warlord Titan (Part 3 - The first leg!)

I have been busy with the glue and the paint and assembled the first let (up to as far as the knee) of my 3D Printed Warlord Titan.

I must say as a relative newbie to 3D Printing I am very impressed with what can be achieved with a very low-cost machine.

The detail in the model is impressive and the printer is doing a great job!

The printed parts are rock-solid. I don't doubt that there will be times when a re-inforcing pin or two may be required, but on the whole - as I said - I am very impressed.

I've decided on a two-tone colour scheme (yellow/blue). As yet there is no weathering - I'll get on to that later - and there is also a heap more armour to apply:

Necromunda model added for scale

More Warlord Titan Stuff:

Warlord Titan (Part 2 - Been busy printing...)

Hi all

Whilst this may be my first post for a few months I have not been idle (and neither has my 3D Printer!)

I have printed, assembled and painted loads more of my Titan project (and I'm still not finished) but I have been remiss in not posting about it. My blog has been horribly ignored for a while and I need to do something about that.

So, here is the first in a series of catch-up posts on the Titan.

So you can see from the photo above that I have printed all the parts required to build the Titan up as far as the knees. The feet have been assembled, spray-undercoated and given a first drybrush. The other bits (in black) just spray-undercoated and the white parts were fresh off the printer when the photo was taken.

I took the photo on my cutting mat to give an idea of scale (the squares are 1cm).

More updates WILL follow!

More Warlord Titan Stuff: